Last updated: September 6, 2026
Toyota Hilux Revo Rocco Body Kit Guide: Front Conversion, Bumper Fitment and Paint
Toyota Hilux Revo / N80 is a fitment reference for buyers and installers. A similar-looking part or broad catalogue title is not enough.
Vehicle identity and audited scope
Vehicle: Toyota Hilux Revo / N80
Scope: 2015+
Guidance separates Hilux Vigo (2005–2015) from Revo/N80 (2015+). The LC200-to-LC300 link was unrelated and is removed. Rocco styling does not prove universal Revo fit; obtain exact body, market, carrier, grille, fender and sensor evidence.
Before ordering
- Confirm VIN, production date, generation, body style and market.
- Photograph bumper, grille, fender, hood, wheel-arch, side-skirt and sensor interfaces.
- List PDC, camera, radar/ACC, washer, exhaust and transferred brackets.
- Pre-fit all major panels and verify mounting points before paint.
- Record gaps and unresolved interfaces for supplier review.
Installation and fitment checks
Compare the supplied component with the original before removal or paint. Check the physical interfaces named above, transfer parts, fasteners and trim. For electrical components, verify power, connector seating, module identity, warning status and existing functions. Coding, calibration, road-use approval and left/right-drive beam behavior remain vehicle- and market-dependent; confirm them with the installer and supplier.
Buyer decision
Proceed only when vehicle evidence, product scope and the installation plan agree. Previous accident repair, non-standard wiring, changed panels or unclear factory equipment require extra review.
Related Tangma product records
No directly verified Tangma product mapping is retained for this page.
Frequently asked questions
What must I send before ordering?
Send VIN or production details, clear photos of the current part, its label and connectors, surrounding interfaces, market and relevant factory options.
Can the listing title prove compatibility?
No. Confirm vehicle identity, original equipment, interfaces and supplied component details together.
When should installation stop?
Stop when a panel, connector, bracket or function does not match. Resolve identity and scope before paint, coding, calibration or trimming.
