Last updated: September 6, 2026
Toyota Prado LC150 Body Kit Guide: Facelift Conversion, Grille, Bumper and Sensors
Toyota Prado LC150 / J150 is a fitment reference for buyers and installers. A similar-looking part or broad catalogue title is not enough.
Vehicle identity and audited scope
Vehicle: Toyota Prado LC150 / J150
Scope: 2009–2023; facelift 2018–2023
Guidance separates LC150/J150 from J250 and notes a 2018–2023 facelift. The LC200-to-LC300 link was unrelated and is removed. No audited product proves a complete LC150 body-kit mapping; confirm bumper, grille, headlamp, fender/hood and sensor interfaces.
Before ordering
- Confirm VIN, production date, generation, body style and market.
- Photograph bumper, grille, fender, hood, wheel-arch, side-skirt and sensor interfaces.
- List PDC, camera, radar/ACC, washer, exhaust and transferred brackets.
- Pre-fit all major panels and verify mounting points before paint.
- Record gaps and unresolved interfaces for supplier review.
Installation and fitment checks
Compare the supplied component with the original before removal or paint. Check the physical interfaces named above, transfer parts, fasteners and trim. For electrical components, verify power, connector seating, module identity, warning status and existing functions. Coding, calibration, road-use approval and left/right-drive beam behavior remain vehicle- and market-dependent; confirm them with the installer and supplier.
Buyer decision
Proceed only when vehicle evidence, product scope and the installation plan agree. Previous accident repair, non-standard wiring, changed panels or unclear factory equipment require extra review.
Related Tangma product records
No directly verified Tangma product mapping is retained for this page.
Frequently asked questions
What must I send before ordering?
Send VIN or production details, clear photos of the current part, its label and connectors, surrounding interfaces, market and relevant factory options.
Can the listing title prove compatibility?
No. Confirm vehicle identity, original equipment, interfaces and supplied component details together.
When should installation stop?
Stop when a panel, connector, bracket or function does not match. Resolve identity and scope before paint, coding, calibration or trimming.
